Push-Fit Fittings
Push-Fit Tee 10mm
SKU PUT10
$4.50incl. GST
In stock · ready to ship
Equal push-fit tee for three 10 mm OD tubes.
Key features
- Splits one line into two, for example to feed a second pole or add a bypass
- Plastic body
How to fit
- Cut the tube square with a tube cutter and check the end is clean and unmarked
- Push the tube in past the first resistance until it stops, then pull back to check it has gripped
- To remove, turn the water off, hold the release collar in and pull the tube out
- A drip when the water goes on usually means the tube is not fully home
Good to know
- For cold water. Drain the line in freezing weather
- Keep grit off the tube end, as it damages the seal inside the fitting
- Maximum working pressure 150 psi (10 bar)